Gas and Electric Oven and Stove Service in Van Nuys
An oven that will not reach temperature, a gas burner that clicks without igniting, or a range surface element that glows unevenly can turn meal preparation into a frustrating exercise. Many Van Nuys homes — especially those built before the 1980s — have gas ranges connected to aging supply lines, which means that a gas smell or a burner that will not light deserves prompt professional attention rather than improvised workarounds.
Sergo Appliance Repair provides oven and stove repair throughout Van Nuys, Northridge, Granada Hills, Sunland and surrounding areas. We service both gas and electric freestanding ranges, slide-in models and standalone ovens installed within cabinetry.
Oven Problems We Diagnose
The oven section of a range depends on a heat source (gas burner or electric element), a temperature sensor, a control board and proper insulation to maintain consistent heat. When any of those components fails, cooking performance suffers — sometimes subtly, sometimes dramatically.
- Oven not heating at all — no ignition, no element glow
- Oven heating unevenly — hot spots, cold zones, inconsistent baking
- Temperature significantly above or below the set point
- Gas oven igniter glowing but not lighting the burner
- Self-cleaning cycle not initiating or not completing
- Oven door not closing flush or locking during self-clean
- Interior light not working
- Error codes on the electronic display
- Broil element not heating
Stovetop and Burner Issues
Stovetop problems affect day-to-day cooking more than oven failures because the surface burners see constant use. Gas burners that click without lighting, electric coils that heat intermittently and glass-top elements with visible cracks all require specific diagnostic approaches.
- Gas burner clicking but not igniting
- Weak or irregular flame on one or more burners
- Electric coil element not heating or heating only partially
- Glass cooktop element not responding to controls
- Gas smell near the range when burners are off
- Spark igniter continuously clicking even when burners are off
- Knobs not turning or not engaging the valve
If you smell gas and the burners are off, open the windows, leave the house and contact your gas utility or fire department before calling for appliance service. A gas leak is a safety priority that should be addressed before any diagnostic work begins.
Gas Safety During Oven and Stove Repair
Gas range work involves testing gas valves, regulators, igniters and burner assemblies. Our technicians carry leak-detection solution and combustible gas detectors. After completing a gas-related repair, the technician tests all connections and confirms there are no leaks before finishing the service call.
Temperature Calibration and Sensor Testing
An oven that runs 25°F hot or 40°F cold can ruin recipes that depend on precise temperatures. Temperature inconsistency may involve a drifting sensor, a failing control board, a weak igniter that takes too long to light the burner, or worn door gaskets that allow heat to escape. The technician uses a separate oven thermometer to verify actual versus displayed temperature, then tests the components in the temperature-control loop.
If your kitchen has a separate cooktop and wall oven rather than a freestanding range, those units have distinct installation and repair considerations covered on our dedicated page.